1989-Montero · fuel system · страница 11 из 53 · Открыть оригинал PDF ↗
SERVICE ADJUSTMENT PROCEDURES CARBURETOR APPEARANCE
r4I.F.L
IDLE SPEED CHECK PROCEDURE
rdmi/aa
Refer to GROUP 0 - Checking and adjustment of the iding
wm
NI4FHsba
IDLE SPEED ADJUSTMENT
Refer to GROUP 0 - Idle Speed inspection and Adjustment.
IDLE SPEED AND MIXTURE ADJUSTMENT (For Unscheduled Maintenance Only) NIc=mF
(I) Remove carburetor from engine (Refer to P.1434.)
(2) Clamp carburetor in a vice with idle mixture adjusting
screw facing up (protect gasket surface from vice jaws.1
(3) Drill a 2 mm (5/64 inch) pilot hole in the casting surround-
ing the idle mixture adjusting screw then redrill the hole to
3 mm (116 inch).
(4) Insert a blunt punch into the hole and drive out plug.
(5) Reinstall carburetor on engine.
(6) Run the cold engine at fast idle until the cooling water
temperature is raised to 85 to 95°C (185 to 205°F)
Оригинальная страница руководства
