1989-Montero · fuel system · страница 27 из 53 · Открыть оригинал PDF ↗
1. Before removing or installing a part, disconnect the
battery - terminal.
2. Before disconnecting battery terminals, turn off the igni-
tion switch. Removal or connection of battery terminals
during engine operation or with the ignition switch ON
could cause erroneous operation of the Engine control
unit or damage to semiconductors.
3. The control harnesses between Engine control unit and
ignition coil [ -terminal] and between Engine control unit
and oxygen sensor are shielded wires with shield ground-
ed to the vehicle body in order to prevent ignition noises
and radio interference. When the shielded wire is faulty,
therefore, the control harness must be replaced.
4. When ECI checker is handled, pay attention to the
following points.
l Avoid rough operation of switches.
l Do not subject ECI checker to shock and other external
forces, heat, etc.
l Keep away water and oil.
l Store ECI checker in a moisture- and dust-free place
and take steps to protect the checker from heat and
vibration.
FBC SYSTEM INSPECTION (USE ECI CHECKER) NI4PDAG

Inspection and maintenance of electric system in the FBC
system can be made quickly by inspecting the Engine control
unit input and output electric signals with the ECI checker and
then by inspecting the component whose signal is abnormal
and the harness between the component and the Engine
control unit.
Using the special tools (FBC Test Harness and ECI Checker),
check the FBC system by the following procedure.
Inspection Procedure:
(I) Turn ignition switch to “LOCK”.
(2) Remove the ECI cover.
(3) Disconnect the Large harness connector and Small har-
ness connector from the Engine control unit.
(4) Set check switch of the ECI checker to OFF.
(5) Set select switch of the ECI checker to A.
(6) Connect the FBC Test Harness to the connectors of the
ECI checker, and then connect the FBC Test Harness to
the Engine control unit and harness connectors.
(7) Perform checks according to the FBC System Check
Procedure chart.
(8) If checker shows any variance from specifications, check
the corresponding sensor and related electrical wiring
then repair or replacement.
(9) After repair or replacement, recheck with the ECI checker
to confirm that the repair has corrected the problem.
(lO)Set check switch of the ECI checker to OFF.
(1 l)Set ignition switch to “Lock”.
(12)Disconnect connectors of the ECI checker and the FBC
Test Harness from the Engine control unit and the body
side harness connectors.
(13)Connect the body side harness connectors to the Engine
control unit.
(14)After completion of the above test make certain that the
trouble has been eliminated on the road test.
