1989-Montero · engine 2'6 · страница 21 из 55 · Открыть оригинал PDF ↗
Removal steps
23. Fuel hose clamp
24. Heat protector
25. Engine mounting front insulator attach-
ing bolt
+* l + 26. Engine assembly
NOTE
(1) Reverse the removal procedui ss to reinstall.
(2) +* : Refer to “Service Poin ts of Removal”.
(3) l + : Refer to “Service Poin ts of Installation”.
OlW636
ta9seDH
SERVICE POINTS OF REMOVAL 16. REMOVAL OF POWER STEERING OIL PUMP/IS. AIR CONDITIONER COMPRESSOR
Remove the oil pump and air conditioner compressor
(with the hose attached).
NOTE
Suspend the removed oil pump (by using wire or similar
material) at a place where no damage will be caused
during removal/installation of the engine assembly.
26. REMOVAL OF ENGINE ASSEMBLY
(1) Check to be sure that all cables, hoses, harness
connectors, etc. are disconnected from the engine.
(2) Lift the chain block slowly to remove the engine
assembly upward from the engine compartment.
SERVICE POINTS OF INSTALLATION
NoaSD*o
26. INSTALLATION OF ENGINE ASSEMBLY
Install the engine assembly. When doing so, check
carefully to be sure that all pipes and hoses are con-
nected, and that none are twisted, damaged, etc.
17. INSTALLATION OF DRIVE BELT (AIR CONDITIONER
COMPRESSOR)
Adjust belt tension. (Refer to GROUP 24 - Service
Adjustment Procedures.)
15. INSTALLATION OF DRIVE BELT (POWER STEERING)
Adjust belt tension. (Refer to GROUP 19 - Service
Adjustment Procedures.)
1. ADJUSTMENT OF ACCELERATOR CABLE
Refer to GROUP 14 - Engine Control.
Оригинальная страница руководства
