1989-Montero · engine 2'6 · страница 46 из 55 · Открыть оригинал PDF ↗
SERVICE POINTS OF REASSEMBLY 10. INSTALLATION OF PISTON PIN
(1) Thread stop plug approximately half way into the
bottom of the receiving tube.
(2) Select the largest diameter piston pin guide that will
pass through piston and rod. install spring, spacer, and
guide into receiving tube.
The piston must be he to float during installation;
check frequently.
(6) Apply hydraulic pressure to pin and adjust stop plug
until stop plug comes in contact with spacer.
(7) Remove piston and pin assembly from anvil and check
piston pin to make sure it is centered. Ifs it is not
centered, adjust stop plug up or down to obtain proper =
centering. The pin stop is now set for any remaining
pistons.
Caution
If the required installation load is out of specifica-
tion, replace piston pin and/or connection rod.
Piston pin press in load: 7500-I 7500 N
(1653-3858 Ibs.)
Оригинальная страница руководства
