Pajero II Workshop Manual 1991 · Электрооборудование автомобиля · страница 31 из 72 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

HEADLAMPANDFRONT COMBINATION LAMP
REMOVAL AND INSTALLATION

ES4GHAN

Removal steps

Front combination lamp
Radiatorgrille
3. Headlamp

SERVICE POINT OF REMOVAL

Mitsubishi MotorsCorporationFeb_1991

REMOVAL OF FRONT COMBINATION LAMP

Remove the front combination lamp mounting screws and
set spring,and remove the frontcombination lampby
pulling it towards the front of the vehicle
NOTE

For the left side, before removing the front combination
lamp, remove the engine coolant reserve tank in advance

Проверка

HEADLAMP LEVELING UNIT

(1) After settingthe headlamp levelling switchtothe"0"
position, remove the headlamp and inspect.

(2) Check to be sure there is no continuity betweenterminals
(1) and (2).

(3) Connect terminal (1) to the battery and connect {erminal
(2) to earth ground:

(4)Check tomake sure themotor is activated(headlamp
reflector operates) for 0.6 to 1.0 second when terminals
(4), (51. (6) and (7) are connected to earth in this order

(5) Next, check to make sure the motor is activated [head-
lamp reflector operates in reverse order or (4)abovel for
0.6 to 1.0 second when terminals (6), (5), (4) and (3) are
connected toearth in this order,

(6) If the headlamp leveling unit isdefective, replace the
entire headlamp assembly:

PWJE9O86

Оригинальная страница руководства