Pajero II Workshop Manual 1991 · Электрооборудование автомобиля · страница 71 из 72 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(2) After turning the ignition switch to ACC or ON, turn the
radioswitchtoONtoraise theantenna pole,and
remove it,together with the rack cable.

(3) Draw out the antenna pole to the maximum extension_
NOTE
If there isbend inthemotorend of the rackcable
remove the bend.

(4) Insert the rack cable into the motor assembly with the rack
cable teeth facing the engine compartment side.

(5) Turnthe rack cableteethtowards the front of the
vehicle (908 to right) so that the rack cablemeshes
wilh the motor gear,

(6) If the rack cable pulls out with no resistance when it is
lightly pulled, then the cable is not meshed with the
motor gear, so check that there are no bends in the
end of the rack cable, and then repeat steps (3) and (4)
above

Settheantennapole verticallyandturntheradio
switchOFFtowinduptherackcable. Insertthe
antenna to the motor antenna side to align it with the
wound-up rack cable

(8) After tightening the ring nut, check the movement of
the antenna bY turning the radio switch ON and OFF.

Оригинальная страница руководства