Pajero II Workshop Manual 1991 · Отопление, кондиционирование и вентиляция · страница 28 из 118 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
REAR AIR MIX DAMPER MOTOR ASSEMBLY, CONTROL SWITCH AND RESISTOR
REMOVAL AND INSTALLATION
Pre-removal and Post-installation
Operation
Removal and Installation of the Rear
Seat
(Refer to GROUP 52Seat)
<Except for Long Body Wagon>
Removal steps
Cover
Airguide
3. Linkage mounting screw
Rear air mix damper motor assembly
<Vehicles with dual NC>
Control switch assembly
<Vehicles with dual AC >
Resistor
Проверка
ESSREBA
REAR AIR MIX DAMPER MOTOR ASSEMBLY CHECK
(1) Checkthat the temperature adjustment selector isnor-
mal. (Refer to P.55-15.1
(2) After the engine has warmed up,check that the link of
the damper motor is at position A when the temperature
adjustmentselectoris attheMAXCOOLposition,and
that it is at positionB when the temperature adjustment
selector is at the MAXHOT position.
CONTROL SWITCH CHECK
Operatetheswitchandusecircuit tester to checkthe
continuity between the terminals in both theand B posi-
tions
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Terminal No. Switch position | 2 | Remark |
|---|---|---|
| position | indicates that continuity there is | |
| position | between the terminals. |
RESISTOR CHECK
Usea circuit tester to measure the resistance between the
terminals shown below.Check that the values measured are
within the standard values
Standard value:
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Measurement terminal | Standard value 9 |
|---|---|
| Between terminals | 43 $ 7% |
| Between terminals | 1.2 + 7% |
PWJE9086
Оригинальная страница руководства
