Pajero II Workshop Manual 1991 · Отопление, кондиционирование и вентиляция · страница 76 из 118 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Service AdjustmentProcedures

<In case the gauge manifold is used>

(1) Turn back the handle of the special toolsand(valve
closed) to install the special tools 0 andthe low pres-
sure service valve and vacuum pump_
NOTE

The high ad low pressure service valve are attached to
the compressor.

(2) Closethe highand lowpressurevalvesof thegauge
manifold.

(3) Connect the charging hose to the special toolsand
asillustrated.

(4} Tighten the handle of the special toolsand(valve
open) .

(51 Start up the vacuum pump
Caution

Do not use the compressor for evacuation.
2Donot operatethecompressorinthevacuum
condition; damage may occur:

(6) Evacuate t0a vacuumreading of100 kPa (1.0 kg/cm?,
14.2 psi) or higher (approx10 minutes).
Turnbackthehandleoftheadaptorvalve(valve
closed)

(8)Stopthe vacuum pump ad allow to stand for 5 minutes_
(9)Check for leaks. (Good if the vacuum is held )

PWJE9086-D

REVISED

Оригинальная страница руководства