POST-COLLISION DIAGNOSIS · 29

POST-COLLISION DIAGNOSIS · 29

Pajero II Workshop Manual 1991 · Система пассивной безопасности (SRS) · страница 29 из 47 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

POST-COLLISION DIAGNOSIS

E13BF2OAA

To inspect and service the SRS aftera collision (whether or
not the airbaghas deployed) , perform the following steps

SRS DIAGNOSISUNIT MEMORY CHECKE13BFZ1AA

Connect the MUT-II to the diagnosis connector (16-pin)
located at the rightor left side of the junction block.

Caution

Make certain that the ignition switch is OFF when
the MUT-II is connected or disconnected:

2_Read(andwritedown)all displayed diagnosis codes_
(Refer toP.52B-7.)

NOTE

If the battery power supply hasbeen disconnected or
disrupted by the collision, the MUT-Il cannot communicate
with the SRS diagnosis unit. Inspect and,if necessary;
repairthe body wiring harness before proceeding further:

Read the service data (fault duration and how many times
memories are erased)usingthe MUT-II,

NOTE

Maximum stored period: 9999 minutes (approximately
days)
Maximumnumber of times to be stored: 250

Erase the diagnosis codes and after waiting 45 seconds
ormore read(andwritedown)all displayed diagnosis
codes(Refer to P.52B-7.)

REPAIR PROCEDURE

E13BF2ZAA

When air bag deploys collision.

Replace the following parts with new ones_
Front impact sensors (Refer to P.52B-33.)
SRS diagnosis unit (SDU)(Refer to P.52B-35.)

Airbagmodule (Refer to P.52B-38.)

Check the following partsandreplace a part if there is a mal-
function.

Clock spring (Refer to P.52B-38.)

Steering wheel, steering column and intermediate joint
(Refer to P52B-31 or GROUP 37Steering wheel and
Shaft )
3Check harnesses for binding, connectors for damage, poor
connections,andterminalsfordeformities.(Referto
P52B-3.)

Оригинальная страница руководства
Страница 29
100%

Назад
Сверху