Pajero II Workshop Manual 1991 · Система пассивной безопасности (SRS) · страница 42 из 47 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
SERVICE POINTS OF INSTALLATION PRE-INSTALLATION INSPECTION
ES2BI04AA
(1)When installing the new airbagmodule and clock spring,
refer to'INSPECTION
Caution
Dispose of an airbagmodule only according to the
specified procedure: (Refer to P.52B-44,)
(21Connect the battery (-} terminal:
(31Connect the MUT-II to the diagnosis connector (16-pin)
located at the right or left side of the junction block
Caution
Make certain that the ignition switch is OFF when
theMUT-II is connected or disconnected.
(4)Reconnect negative terminal of battery, ad turn the igni-
tion key to theON'position.
(5)Conduct self-diagnosis using theMUT-II toensureen-
tireSRS operatesproperly,exceptopencircuit f air
bagmodule (Diagnosis code No.22).(Refer to P.52B-7.)
(6)Turn the ignitionkeyto theLOCKposition, disconnect
the negative battery cable and tape the terminal:
Caution
Wait at least 60 seconds after disconnecting the bat-
tery cable before doing any further work: (Refer to
P52B-4.)
INSTALLATION OF CLOCK SPRING
Align the mating mark ad "NEUTRALposition indicator of
theclock spring;and,after turning the front wheels to the
straight ahead position, install the clock spring to the column
switch.
Caution
Iftheclock spring's matingmarkisnot properly
aligned,the steering wheelmaynot be completely
rotational duringa turn, or the flat cable within the
clock spring may be severed, obstructing normal op-
eration of the SRS and possiblyleading to serious
injury to the vehicle's driver:
Оригинальная страница руководства
