MANUALS · INTAKE AND EXHAUST [15] · страница 16 из 30 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Проверка
Check the followingpoints; replace the partifa problem is found.
1) Damage or cracking of any part:
(2) Clogging of the negative pressure (vacuum) outlet port; or
clogging of the water or gas passages
SERVICE POINTS OF INSTALLATION
10. INSTALLATION OF INTAKE MANIFOLD GASKET
Install the gaskets so that the projections face in the direc-
tions shown in the illustration:
9INSTALLATION OF INTAKE MANIFOLD8. CONE DISC SPRING
Tighten the intake manifoldmountingnuts one bank after the
other by the following procedure
(1) Tighten the nuts in the right bank to 7 Nm (0.7 kgm, 5
ftIbs ).
(2) Tighten the nuts in the left bank to 20 to 23 Nm (2.0 to
2.3 kgm;14 to 17 ft.Ibs )
(3) Tighten the nuts in the right bank to 20 to 23 Nm (2.0 to
2.3 kgm, 14 to 17 ft.lbs )
(4) Repeat steps (2) and (3) one more time respectively.
2.INSTALLATION OF HIGH-PRESSURE FUEL HOSE
(1) Apply a little amount of new engine oil to the O-ring
Caution
Be sure to prevent the engine oil from entering into
the delivery pipe:
(2) Insert the hose, being careful not to damage the O-ring,
and tighten securely:
Оригинальная страница руководства
