MANUALS · FRONT SUSPENSION [33] · страница 27 из 28 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

BALL JOINT DUST COVER REPLACEMENT

(1) Remove the clip ring and the dust cover.

(2) Apply multi-purpose grease to the lip and insideof the
dust cover

(3) Use vinyl tape to tape the stabilizer Iink where shown in
the illustration, and then install the dust cover to the sta-
bilizer link.

(4} Secure the dust cover with the clip ring:
NOTE

When installing the clip ring. align it so that its ends are
located at a 90o angle from the axis of the stabilizer link:

SERVICE POINTS OF INSTALLATION

4.INSTALLATION OF BUSHING

Check which type of busing is being used by the posi-
tion of the slit, and then install the bushing so that the
slit is in the position shown in the illustration

3INSTALLATION OF STABILIZER BAR BRACKET

Position the stabilizer bar So that the marking on the sta-
bilizer bar and the edge of the bracket becomes the ref-
erence value, and then tighten the stabilizer bar bracket
mounting bolt

Reference value:Approx: 10 mm (0.4 in:)

Оригинальная страница руководства