1987-Montero · Brakes a · страница 15 из 41 · Открыть оригинал PDF ↗
c ;, ..+qj 4
Caution
‘1. Use the specified brake fluid. Avoid using a rni&$ of
the specified brake fluid and other fluid.
2. Of brake fluid is exposed to the, air, it will absorb
moisture; as water is absorbed from the atmosphere,
the boiling point of the brake fluid will decrease and the
braking performance will be seriously impaired. For this
reason, use a hermetically sealed 1 lit. (1.06 U.S.qt., 0.88
Imp.qt.) or 0.5 lit. (0.52 U.S.qt., 0.44.Imp.qt.) brake fluid
container.
3. Firmly close the cap of the brake fluid container after
use.
h,
OF BRAKE f%i%& ‘,.:. s
INSPECTION AND REPLACEMENT
1. Check the wear condition of the brake pads through the
inspection hole in the caliper body.
f. ,..
Limit : 1.0 mm
(.039 in.)
2. If the pad assemblies are worn beyond the limit, replace
them as following procedure.
(1)Pull out the spigot pins.
(2)Use pliers to pull the stopper plug out to the side.
(3)Remove the caliper assembly by moving it upward or
downward at an angle.
NOTE
Hold the front brake assembly by suspending it with.
wires or other suitable means in such a manner that
the brake hose is not twisted.
6’
‘.
!k.
(4)Remove the pad assemblies, outer shim, pad clips,
Оригинальная страница руководства
