1987-Montero · Brakes a · страница 17 из 41 · Открыть оригинал PDF ↗
(12)Install the new pad assemblies to the mounting
support.
Caution
The pad assemblies should be replaced as sets (inner
and outer) for both the left and right wheels at the
same time.
.-
(13)Apply a thin coat of specified grease to the plug plate
and stopper .plug contact surface. . . ” I:.,
.,*
Specified grease : Brake grease SAE J310, NLGI ’ 1:
No. 1 ,!. ;.
(14) Install the caliper assembly.
(15)Use the following procedure to measure the brake
dragging force:
0 Start the engine and depress the brake pedal for 5
seconds. . . . . ,.“p’
0 Turn engine off.
0 Rotate the brake disc a few revolutions.
@ Use a spring scale as illustrated to measure the -
brake drag.
‘i;
0 The difference between brake drag and rotational
force (measured at the time of inspection) should, i
not exceed the standard value.
Standard value : 57 N (13.1 Ibs.) or less [Drag-
ging torque : 4 Nm (3 ftlbs.) ,;
or less] /
8 If the difference exceeds the standard value, re-
move the caliper body and disassemble it. Check
the piston and seal for deterioration, corrosion, dirt * a
or scoring. (Refer to P.5-29.)
Оригинальная страница руководства
