1989-Mitsu-Factory Manual · AC system · страница 40 из 42 · Открыть оригинал PDF ↗
SERVICE POINTS OF DISASSEMBLY
1. REMOVAL OF CLUTCH HUB (lOPA%)
(1) Secure the compressor in a vise.
(2) If the clutch hub cannot be pulled off by hand, screw in
an 8 mm (.315 in.) completely threaded bolt so as to
raise the clutch hub so it can be removed.
4. REMOVAL OF ROTOR ASSEMBLY
Using a plastic hammer, lightly tap the rotor off the shaft.
10. REMOVAL OF THROUGH BOLT
Remove the through bolt after first securing the rear
housing of the compressor by placing it in a vise.
Caution
If the through bolt is removed without first doing so,
the rear housing wiil become uncoupled and compres-
sor oil will escape.
12. REMOVAL OF FELT (lOPA15)
Using a flat-tip 8 screwdriver, remove the felt from the
front housing.


Проверка
NuTGplc
o Check the surface of the clutch hub for scoring or bluing.
J Check the surface of the rotor for scoring or bluing.
8 Check the sealing surfaces for cracks, scratches and
deformation.
l Check the front housing for cracks or scoring on the
sealing surfaces.
e Check the compressor shaft for scoring.
--
