1989-Mitsu-Factory Manual · AC system · страница 42 из 42 · Открыть оригинал PDF ↗
e REFILL OF COMPRESSOR OIL
When the compressor is disassembled, supply compres-
sor oil of which quantity is the same as that which went
out when the compressor is disassembled adding 20 cc
(0.7 fl.oz.) with it from the suction hole side.
Specified oil : DENS0 OIL 6 or SUNISO 56s
NOTE

1. The quantity of compressor oil to supply at when exchang-
ing the compressor with new one.
6P148 : 90 cc (3.2 fl.oz.)
lOPA : 40 cc (1.4 fl.oz.)
2. When exchanging the whole refrigerant system, do not
supply the compressor oil with it for it is supplied before
hand.
7. INSTALLATION OF CLUTCH COIL
The clutch coil must be aligned with the pin in the
compression housing.
. ADJUSTMENT OF CLUTCH CLEARANCE
(1) Connect the magnetic clutch to the battery.
(2) The clutch hub wiil be attracted to and fit closely to the
rotor.
(3) Use a shim(s) to adjust so that the amount of
movement of the clutch hub is as described below.
Standard value
6P148 : 0.4-0.7 mm (.016-.028 in.)
lOPA : 0.35465 mm (.0138-.0256 in.)
NOTE
1. For the 6P148, use a feeler gauge for clutch
clearance measurement.
2. Remove clearance adjusting shims to decrease
clutch clearance. Add shims selected from the
following table to increase clutch clearance.
Clearance Adjustment Shims


(4) Turn the rotor by hand to confirm that it rotates freely.
