1989-Mitsu-Factory Manual · mpi system · страница 44 из 48 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL
14. REMOVAL OF HIGH PRESSURE HOSE TO FUEL PUMP
CONNECTION
Caution
Cover the hose connection with rags to prevent splash
of fuel that could be caused by some residual pressure
in the fuel pipe line.
Проверка
NI4GcP.m
l Check the hoses and the pipes for crack or damage.
l Check the fuel tank cap for malfunction.
l Check the fuel tank for deformation, corrosion or crack.
l Check the fuel tank for dust or foreign material.
NOTE
If the inside of the fuel tank is to be cleaned, use any one
of the following:
(1) Kerosene
(2) Trichloroethylene
(3) A neutral emulsion type detergent
l Check the in-tank fuel filter for damage or clogging.
l Check the check valve for malfunction.
CHECKING TWO-WAY VALVE
A smiple way of inspection, however, may be adopted in
which the overfill limiter is removed and then air is lightly
blown into either the inlet or outlet. If the air passes after a
slight resistance, overfill limiter is in good condition.
SERVICE POINTS OF INSTALLATION 15. INSTALLATION OF RETURN HOSE/b VAPOR HOSE
NUGDAK
When attaching the hoses to the pipes, be sure that the
hose is attached until its end comes in touch with the
bulge of the pipe as shown in the illustration.
Оригинальная страница руководства
