Раздаточная коробка — страница 2

transfer case · 2

1991-Montero-Service-Manual · transfer case · страница 2 из 19 · Открыть оригинал PDF ↗

NOTE: With switch removed, check continuity between switch
connector terminal and switch body. With switch installed,
check continuity between switch connector terminal and
transfer case.

4WD Indicator Light Switch (RAM-50)
With switch removed, check continuity between connector
terminal and switch body. With switch end pressed, there should be no
continuity. With switch end released, there should be continuity.

Center Differential Lock Operation Detection Switch (Montero)
Check continuity between terminals at Brown wire connector
terminal on top of transfer case. With transfer control lever in "4H"
position, there should be no continuity. With transfer control lever
in "4HLc" position, there should be continuity. See Fig. 2.

4WD Operation Detection Switch (Montero)
Check continuity between terminals at Black wire connector
terminal on top of transfer case. With transfer control lever in "2H"
position, there should be no continuity. With transfer control lever
in "4H" position, there should be continuity. See Fig. 2.

Center Differential Lock Detection Switch (Montero)
Check continuity between terminals at Brown wire connector
terminal on side of transfer case. With transfer control lever in "4H"
position, there should be no continuity. With transfer control lever
in "4HLc" position, there should be continuity. See Fig. 2.

2WD-4WD Detection Switch (Montero)
Check continuity between terminals at Black wire connector
terminal on side of transfer case. With transfer control lever in "4H"
position, there should be no continuity. With transfer control lever
in "2H" position, there should be continuity. See Fig. 2.

HI/LO Detection Switch (Montero)

Check continuity between terminals at White wire connector
terminal on side of transfer case. With transfer control lever in "N"
(between "4HLc" and "4LLc") position, there should be no continuity.
With transfer control lever in "4HLc" position, there should be
continuity. With transfer control lever in "4LLc" position, there
should be continuity. See Fig. 2.

Оригинальная страница руководства
NOTE: With switch removed, check continuity between switch
100%

Назад
Сверху