1991-Montero-Service-Manual · transfer case · страница 11 из 19 · Открыть оригинал PDF ↗
Disassembly
Remove snap ring, 2WD-4WD synchronizer hub and synchronizer
spring. Remove outer synchronizer ring, synchronizer cone and inner
synchronizer ring. Remove drive sprocket and needle bearing from front
drive pinion. Inspect inner and outer synchronizer rings and cone for
excessive wear. Install inner and outer synchronizer rings and cone
onto drive sprocket. Measure distance between drive sprocket and outer
synchronizer. If distance is less than .0118" (.300 mm) replace
synchronizer parts as a set.
Reassembly
Install drive sprocket and needle bearing onto front drive
pinion. Apply transfer case gear oil to contacting surfaces of inner
and outer synchronizer rings and synchronizer cone. Install inner and
outer synchronizer rings and synchronizer cone. Install synchronizer
spring, 2WD-4WD synchronizer hub and snap ring to complete assembly.
When installing new snap ring, select thickest ring that will fit into
groove. Acceptable snap ring clearance is 0-.003" (0-.080 mm).
Fig. 8: Exploded View Of 2WD-4WD Synchronizer (Montero)
Courtesy of Mitsubishi Motor Sales of America.
TRANSFER CASE REASSEMBLY
NOTE: ALWAYS replace all gaskets, oil seals, snap rings and spring
pins with new parts. Coat both sides of gaskets and bolt
threads with sealant. Lubricate all sliding and rotating
parts with transfer case gear oil before assembling.
Оригинальная страница руководства
