1991-Montero-Service-Manual · transfer case · страница 16 из 19 · Открыть оригинал PDF ↗
mm) to clearance measured and install spacer of similar thickness.
Install rear output shaft oil seal (apply grease to lip of seal).
Install rear cover oil seal (apply grease to lip of seal).
11) Before installing rear cover, snap ring and spacer
thicknesses must be determined. Measure protrusion of rear output
shaft bearing. Measure inset of both stages of cover. Subtract inset
recess from rear bearing protrusion. Select a snap ring which adjusts
difference between inset recess and rear bearing protrusion, and
spacer thickness to 0-.004" (0-0.10 mm). Evenly apply sealant to rear
cover and install cover. Tighten bolts to specification. Refer to the
TORQUE SPECIFICATIONS table.
12) Install speedometer gear, ensuring mating marks match
according to number of gear teeth. Install speedometer gear sleeve
clamp and tighten bolt to specification. See Fig. 10.
13) Apply sealant to poppet plug threads. Install poppet
steel balls, springs and poppet plugs and tighten to specification.
Install detection switches, steel balls and gaskets. See Fig. 12.
Install dynamic damper and tighten bolts to specification.
Fig. 12: Installation Of Detection Switches (Montero)
Courtesy of Mitsubishi Motor Sales of America.
Моменты затяжки
Оригинальная страница руководства
