Раздаточная коробка — страница 14

transfer case · 14

1991-Montero-Service-Manual · transfer case · страница 14 из 19 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 14
Иллюстрация 2, страница 14
Иллюстрация 3, страница 14
Иллюстрация 4, страница 14
Иллюстрация 5, страница 14
Иллюстрация 6, страница 14
Иллюстрация 7, страница 14
Иллюстрация 8, страница 14
Иллюстрация 9, страница 14
Иллюстрация 10, страница 14
Иллюстрация 11, страница 14
Иллюстрация 12, страница 14
Иллюстрация 13, страница 14
Иллюстрация 14, страница 14
Иллюстрация 15, страница 14
Иллюстрация 16, страница 14
Иллюстрация 17, страница 14
Иллюстрация 18, страница 14
Иллюстрация 19, страница 14
Иллюстрация 20, страница 14
Иллюстрация 21, страница 14
Иллюстрация 22, страница 14
Иллюстрация 23, страница 14

Fig. 10: Aligning Speedometer Sleeve
Courtesy of Mitsubishi Motor Sales of America.

Reassembly (Montero)

1) Install input gear and front output shaft oil seals into
transfer case housing. Install transfer input gear assembly baffle
plate and input gear seal. Pack grease between lips of seals and press
seal circumference uniformly.

2) Install 2WD-4WD shift lug into transfer case. Install
spring retainer and spring to shift rail and install into shift lug.
Press on shift rail to align spring pin holes in shift rail and shift
lug. While holding shift rail, tap spring pin into place with slit
facing center of shift rail.

3) Install transfer input gear assembly and snap ring. Select
thickest snap ring that will fit into groove. Allowed snap ring
clearance is 0-.0024" (0-.060 mm). Insert needle bearing onto transfer
drive shaft assembly. Install high-low synchronizer sleeve and shift
fork assembly. Install transfer drive shaft assembly.

4) Install transfer countergear shaft thrust washers, needle
bearings, bearing spacer and transfer countergear. Install one thrust
washer at each end of transfer countergear. Ensure tab on thrust
washers fits into groove of transfer case. Install counter gear shaft
from transmission case side so lock plate groove is aligned with lock
plate. Install lock plate. Install side cover and gasket.

5) Install bearing retainer. If reusing bearing retainer
bolts, apply Locking Adhesive (3M 4170 Stud Lock) to threads. Install
oil dam cover. Install differential lock hub, snap ring, steel ball
and sleeve. Select thickest snap ring that will fit into groove.
Allowed snap ring clearance is 0-.003" (0-.08 mm). Install 2WD-4WD
synchronizer sleeve, 2WD-4WD shift fork, spring, spring seat and 2WD-

Оригинальная страница руководства
Fig. 10: Aligning Speedometer Sleeve
100%

Назад
Сверху