1989-Montero · Intro specs electrical · страница 10 из 22 · Открыть оригинал PDF ↗
WIRING HARNESSES
1. Secure the wiring harnesses by using clamps. However,
for any harness which passes to the engine or other
vibrating parts of the vehicle, allow some slack within a
range that does not allow the engine vibrations to cause
the harness to come into contact with anv of the
surrounding parts.
Then secure the harness by using a clamp.
In addition, if a mounting indication mark (yellow tape) is
on a harness, secure the indication mark in the specified
location.
2. If any section of a wiring harness contacts the edge of a
part, or a corner, wrap the section of the harness with tape
or something similar in order to protect it from damage.
3. When disconnecting a connector, be sure to pull only the
connector, not the harness.
4. Disconnect connectors which have catches by pressing in
the direction indicated by the arrows in the illustration.
Оригинальная страница руководства
