1989-Montero · Intro specs electrical · страница 12 из 22 · Открыть оригинал PDF ↗
INTRODUCTION - Precautions Before Service
| Nominal size | ||
|---|---|---|
| 0.3 mm* 0.5 mm2 | AWG 22 | |
| 0.85 mm’ ’ | ii% :: | |
| 1.25 mm | AWGIB | |
| 2.0 mm’ | ||
| 3.0 mmZ 5.0 mm2 | 2% 1: AWGlO |
Таблица в оригинале
2. If additional optional equipment is to be installed in the
vehicle, follow the procedure listed in the appropriate
instruction manual; however, be sure to pay careful
attention to the following points:
(1) In order to avoid overloading the wiring, take the
electrical current load of the optional equipment into
consideration, and determine the appropriate wire size.
(2) Where possible, route the wiring through the existing
harnesses.
(3) If an ammeter or similar instrument is to be connected
to a live-wire circuit. use tape to protect the wire, use a
clamp to secure the wire, and make sure that there is
no contact with any other parts.
(4) Be sure to provide a fuse for the load circuit of the
optional equipment.
TUBES AND OTHER RUBBER PARTS
Be careful to avoid spilling any gasoline, oil, etc., or rubber
parts. they might be adversely affected.
Смазочные материалы
In accordance with the instructions in this Service Manual,
apply the specified lubricants in the specified locations during
assembly and installation.
BRAKE FLUID
Be careful to avoid spilling any brake fluid on painted
surfaces, because the paint coat might be discoiored or _
damaged.
Оригинальная страница руководства
