Pajero II Workshop Manual 1991 · Наружное оборудование кузова · страница 16 из 53 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
SERVICE POINTS OF REMOVAL
REMOVAL OF FRONT DooR SIDE GARNISH/2.REAR
DOORSIDEGARNISH/S.FRONTFLARE/8.REAR
FLARE/9.SIDE SILL GARNISH
(1) Apply masking tape to the outside circumference of
each side garnish:
(21 Insertfishing line [00.8mm (0.03 in.)l in between
the body and the side garnish, and pull both ends al
ternately to cut the adhesive section and remove the
side garnish:
(31Pullthe sectionoftheside garnishwiththe clips
towards you to remove the clips
Caution
Whenreusingthesidegarnish,removeby
pullingthe fishing line along the edge of the
S0asnottheofthe
bodyto damageedge
side garnish:
If the adhesive is difficult to remove, heat it to
4OPC (1049F)_
Scrape off the double-sided adhesive tape with a resin
spatula
(51Tear off the masking tape
(6) Wipe the body surface clean with a rag moistened with
isopropyl alcohol.
4.17REMOVAL OF BLIND RIVETS
Usedrill [04.0-5.Srm(0.16-0.22 in.)Ito breakthe
rivet by drillinghole, and remove the blind rivet.
Оригинальная страница руководства
