FRONT DOOR GLASS ADJUSTMENT

1989-Mitsu-Factory Manual · Кузов · страница 20 из 104 · Открыть оригинал PDF ↗

NmFAab

‘I. Remove the door trim and waterproof film. (Refer to P.23-
36.)

2. Raise the door glass fully, and then adjust the following
items so that the door glass fits evenly into the window
glass runchannel all the way around.
Loosen the screws and/or bolts securing the window and
rear lower sash.
Move the window, rear lower sash and the sub roller
guide (vehicles without ventilator window) of the window
regulator to adjust the door glass position.

VENTkATOR WINDOW ADJUSTMENT N23FJAh

I. Remove the door trim and waterproof film. (Refer to P.23
36.)

2. Remove the ventilator window. (Refer to P.2339.)
3. Adjust the ventilator window by turning the adjusting nut
so that the ventilator window can be operated smoothly.

NOTE

Fix the adjusting nut by bending the lock washer after the
adjustment.

REAR DOOR GLASS ADJUSTMENT

NZWFBE

1. Remove the door trim and waterproof film. (Refer to P.23-
36.)

2. Raise the door glass fully, and then adjust the following
items so that the door glass fits evenly into the window
glass runchannel all the_way around:
(I) Loosen the screw and/or bolts securing the window
center sash.

(2) Move the window center sash to adjust the door glass
position.

INSIDE HANDLE ADJUSTMENT

Nu-

1. Remove the door trim and waterproof film. (Refer to P.23-
36.)

2. Move the mounting position of the inside handle longitudi-
nally in order to adjust the play of the inside handle.

Standardvalue : 4-10 mm (.16-.40 in.)

OUTSIDE HANDLE ADJUSTMENT

lypFHAl

FRONT DOOR AND REAR DOOR

1. Remove the door trim and waterproof film. (Refer to P.23
36.)

2. Disconnect the outside Gandle from the outside handle
rod, and turn it right to left to adjust the outside handle
play.

Caution

The rod snap must be replaced.

Standard value : 3-8 mm (.I&.31 in.)

Оригинальная страница руководства