1989-Mitsu-Factory Manual · Кузов · страница 79 из 104 · Открыть оригинал PDF ↗
12. REMOVAL OF REAR ROOF RAIL TRIM
Refer to P. 23437.
13. REMOVAL OF REAR HEADLINING/14. FRONT HEAD-
LINING
(1) Remove the dome light.
(2) Slowly peel the headlining away, beginning with the
corner of the roof panel.
Caution
Make sure that the headlining is removed slowly; as
the sponge portion of the headlining is left behind on
the roof panel,
(3) Thoroughly remove the drying sealant and sponge left
behind on the roof panel by using a toluol solution, etc.
Caution
Make sure that all remaining sealant and sponge are
thoroughly removed, as they produce uneven sur-
faces when the headlining is bonded to the roof
panel,
SERVlCE POINTS OF INSTALLATION
14. APPLICATION OF SEALANT TO FRONT HEADLINING/
13. REAR HEADUNING
(1) Evenly apply the specified sealant to the roof panel.
When the headlining (rear) is installed, couple the room
dome light connector, put it through the cut hole in the
lining, and bond the lining so that the lining cut hole
matches the dome light attaching hole.
Specified sealant : 3M ART Part No. 8080 or 3M
Adhesive EC-1368, or equivalent
(2) Using care to prevent wrinkles and slackness, bond the
headlining and insert the edges securely into the roof
panel flange by using a spatula, etc.
(3) Bond the headlining edges as shown.
Оригинальная страница руководства
