1989-Mitsu-Factory Manual · Кузов · страница 24 из 104 · Открыть оригинал PDF ↗
REMOVAL
(1) Remove or disconnect the following parts: -
Air cleaner
High-tension cable <2.6L Engine>
Air conditioner vacuum solenoid valve connector
<2.6L Engine>
Accelerator cable
Brake booster vacuum hose
Automatic transmission oil cooler hoses
Radiator assembly
Engine control wiring harness and control wiring
harness connection <3.OL Engine>
Ignition coil connector <3.OL Engine>
Power transistor connector <3.OL Engine>
LC filter connectors <3.OL Engine>
Noise suppression capacitor <3.OL Engine>
Exhaust gasrecirculation (EGR) valve connector
<3.OL Engine>
Idle speed control motor connector <3.OL Engine>
Throttle position sensor connector <3.OL Engine>
Transmission shift lever knob <Manual
transmission>
Heater hoses
Steering shaft joint
Power steering oil reservoir assembly and body
connection <3.OL Engine>
Vacuum hoses
Fuel main hose <3.OL Engine>
Fuel return hose <3.OL Engine>
Vapor hoses
Air conditioner compressor and lines connection
Air conditioner compressor connector
Brake tube and brake hose connection
Transmission control rod (B) <Automatic
transmission>
Brake tube-and blend proportioning valve con-
nection <2.6L Engine>
Brake tube and connector assembly connection
<3.OL Engine> ,
Transfer shift lever knob
Front and rear seats
Parking brake cables
Hydraulic clutch hose
Fuel pipe and body connection <2.6L Engine>
Speedometer cable (transmission side)
Fuel filler hose
Battery cable (+) and starter motor connection
Battery cable (-) and engine connection
Alternator connectors
Breather hose
Engine ground (on body side)
4WD indicator wiring harness and transmission
wiring harness connection
Engine coolant temperature gauge unit connector
Engine coolant temperature sensor
Therm0 switch connector <Automatic transmis-
sion>
Rear combination light connector
Rear side marker light connector
Frame wiring harness and back door wiring
harness connection
Therm0 switch connector for air conditioner
Oil pressure gauge unit connector
Frame wiring harness and side wiring harness
connection <4-door vehicles>
Frame wiring harness and front wiring harness
connection
Oxygen sensor connector
Distributor connector
Carburetor control wiring harness and control
wiring harness connection <2.6L Engine>
Rear air conditioner liquid line -+doorvehicles>
Rear air conditioner suction line <4-door vehicles>
Door opening trim
(2) After removing the body mounting bolts and the body
shims, insert wood blocks into the body and gently lift with
a crane.
Caution
Hoist the body carefully after assuring that all the con-
nections between body and frame and engine are
separated.
Sling wires with a suitable bar or frame used and with
good protection made by fitting coverings at necessary
points.
Оригинальная страница руководства
