1991-Montero-Service-Manual · trouble shooting · страница 7 из 63 · Открыть оригинал PDF ↗
| Engine overheated See ENGINE COOLING SYSTEM article | |
|---|---|
| Engine oil too heavy Check that proper viscosity oil is used | |
| Poor battery-to-starter Check that all connections between battery and starter are clean and tight | |
| Current draw too low or See Bench Tests in too high STARTER article | |
| Bent armature, loose pole See STARTER article shoes screws or worn bearings | |
| Burned solenoid contacts Replace solenoid | |
| Faulty starter Replace starter | |
| Starter Engages Engine Only Momentarily | Engine timing too far See Ignition Timing in advanced TUNE-UP article |
| Overrunning clutch not Replace overrunning engaging properly clutch. See STARTER article | |
| Broken starter clutch See STARTER article | |
| Broken teeth on engine Replace flywheel and flywheel check starter pinion gear for damage | |
| Weak drive assembly See STARTER article thrust spring | |
| Weak hold-in coil See Bench Tests in STARTER article | |
| Starter Drive Will Not Engage | Defective point assembly See Testing in STARTER article |
| Poor point assembly ground See Testing in STARTER article | |
| Defective pull-in coil Replace starter solenoid | |
| Starter Relay Does Not Close | Dead battery Charge or replace battery as necessary |
| Faulty wiring Check all wiring and connections leading to relay | |
| Neutral safety switch Replace neutral safety faulty switch | |
| Starter relay faulty Replace starter relay |
Таблица в оригинале
Оригинальная страница руководства
