1991-Montero-Service-Manual · trouble shooting · страница 25 из 63 · Открыть оригинал PDF ↗
| Incorrect injector pump Check pressure, see housing pressure FUEL SYSTEMS | |
|---|---|
| Engine Overheating | Cooling system leaks Check cooling system and repair leaks Belt slipping or damaged Check tension and/or replace belt Thermostat stuck closed Remove and replace thermostat, see ENGINE COOLING Head gasket leaking Replace head gasket |
| Oil Light on at Idle | Low oil pump pressure Check oil pump operation, see ENGINES Oil cooler or line Remove restriction restricted and/or replace cooler |
| Engine Won’t Shut Off | Injector pump fuel solenoid Remove and check does not return fuel valve solenoid and replace to OFF position if needed |
| VACUUM PUMP DIAGNOSIS | |
| Excessive Noise | Loose pump-to-drive Tighten screws assembly screws Loose tube on pump assembly Tighten tube Valves not functioning Replace valves properly |
| Oil Leakage | Loose end plug Tighten end plug Bad seal crimp Remove and re-crimp seal |
FUEL INJECTION TROUBLE SHOOTING
NOTE: This is GENERAL information. This article is not intended
to be specific to any unique situation or individual vehicle
configuration. The purpose of this Trouble Shooting
information is to provide a list of common causes to
problem symptoms. For model-specific Trouble Shooting,
refer to SUBJECT, DIAGNOSTIC, or TESTING articles available
in the section(s) you are accessing.
BASIC FUEL INJECTION TROUBLE SHOOTING CHART
| CONDITION | POSSIBLE CAUSE CORRECTION |
|---|---|
| Engine Won’t Start (Cranks Normally) | Cold start valve inoperative Test valve and circuit Poor connection;vacuum or Check vacuum and wiring electrical connections |
| Contaminated fuel Test fuel for water or alcohol | |
| Defective fuel pump relay Test relay and or circuit wiring | |
| Battery too low Charge and test battery |


