1991-Montero-Service-Manual · trouble shooting · страница 58 из 63 · Открыть оригинал PDF ↗
| Column not correctly aligned | See STEERING COLUMNS article | |
|---|---|---|
| Broken lower joint | Replace joint | |
| Horn contact ring not | See STEERING COLUMN article | |
| Bearing not lubricated | See STEERING COLUMN article | |
| Shaft snap ring not properly seated | Reseat or replace snap ring | |
| Plastic spherical joint not lubricated | See STEERING COLUMN article | |
| Shroud or housing loose | Tighten holding screws | |
| Lock plate retaining ring not seated | See STEERING COLUMN article | |
| Loose sight shield | Tighten holding screws | |
| High Steering Shaft Effort | Column assembly misaligned | See STEERING COLUMN article |
| Improperly installed dust shield | Adjust or replace | |
| Tight steering universal joint | See STEERING COLUMN article | |
| High Shift Effort | Column is out of alignment | See STEERING COLUMN article |
| Improperly installed dust shield | Adjust or replace | |
| Seals or bearings not lubricated | See STEERING COLUMNS article | |
| Mounting bracket screws too long | Replace with new shorter screws | |
| Burrs on shift tube | Remove burrs or replace tube | |
| Lower bowl bearing assembled wrong | See STEERING COLUMN article | |
| Shift tube bent or broken | Replace as necessary | |
| Improper adjustment of shift levers | See STEERING COLUMN article | |
| Improper Trans. Shifting | Sheared shift tube joint | Replace as necessary |
| Sheared lower shaft lever | Replace as necessary | |
| Improper shift lever adjustment | See STEERING COLUMN article |
Таблица в оригинале
Оригинальная страница руководства
