Поиск неисправностей — страница 31

trouble shooting · 31

1991-Montero-Service-Manual · trouble shooting · страница 31 из 63 · Открыть оригинал PDF ↗

connections for
tight and clean
connections
Ignition switch faulty Adjust or replace
or misadjusted ignition switch as
necessary
Starter Cranks
Engine Slowly
Battery weak or Charge or replace
defective battery as necessary
Engine overheated See ENGINE COOLING
SYSTEM article
Engine oil too heavy Check that proper
viscosity oil
is used
Poor battery-to-starter Check that all
connections between
battery and starter are
clean and tight
Current draw too low or See Bench Tests in
too high STARTER article
Bent armature, loose pole See STARTER article
shoes screws or worn
bearings
Burned solenoid contacts Replace solenoid
Faulty starter Replace starter
Starter Engages
Engine Only
Momentarily
Engine timing too far See Ignition Timing in
advanced TUNE-UP article
Overrunning clutch not Replace overrunning
engaging properly clutch. See STARTER
article
Broken starter clutch See STARTER article
Broken teeth on engine Replace flywheel and
flywheel check starter pinion
gear for damage
Weak drive assembly See STARTER article
thrust spring
Weak hold-in coil See Bench Tests in
STARTER article
Starter Drive
Will Not Engage
Defective point assembly See Testing in STARTER
article
Poor point assembly ground See Testing in STARTER
article
Defective pull-in coil Replace starter
solenoid
Starter RelayDead battery Charge or replace
Таблица в оригиналеТаблица: оригинал страницы 31
Оригинальная страница руководства
connections for
100%

Назад
Сверху