MANUALS · EXTERIOR [51] · страница 40 из 54 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Проверка
OUTPUT SHAFT END PLAY
Checktheoutput shaftendplay bv followingthesteps
below.
(1) Placea dial gauge as shown in the figure; then move the
output shaft in theaxial direction and measure the end
play:
Standard value:0-0.2mm (0-0.008 in.)
(2) If the end play exceeds the standard value, replace the
P.T.O, assembly
DRIVE SHAFT
REMOVAL AND INSTALLATION
SERVICE POINTS OF REMOVAL
Before removing the bearing bracket attaching bolt,make
alignment markson the rear shaft assembly, front shaft
assembly and sleeveyokeassembly
Оригинальная страница руководства
