MANUALS · EMISSION CONTROL [17] · страница 39 из 46 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(6) Ifthe voltage is outside the standard value, adjust by loosen-
ing the lever position sensor mounting screw and turning the
lever position sensor body: After adjusting, securely tighten
the screw:

NOTE

The output voltage will increase if the lever position sensor
body is turned in an anti-clockwise direction

Turn the ignition switch to "OFF"_

Adjusttheaccelerator cable play.

ENGINE SPEED SENSOR INSPECTION

Disconnect the engine speed sensor connectors.
Measuretheresistancebetweentheengine speed
sensor terminals

Standard value: 1.31.9 kQ

ENGINECOOLANTTEMPERATURESENSOR INSPECTION

Remove the engine coolant temperature sensor.

(1)

Whilethesensorsectionoftheenginecoolant
temperaturesensorissubmerged,measurethe
resistance between (B) terminal and the body_
Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Temperature [PC (PF)]	Resistance value (k 9)
0 (32)	8.6
20 (68}	33
40 (104)	1.5
80 (176)	0.3

If the resistance differs largely from the standard value, re-
place the engine coolant temperature sensor

After applying specified sealant to the thread, tighten to
the specified torque.

Specified sealant:3M Nut Locking Part No. 4171 or
equivalent
Tightening torque:10-12 Nm (1.0-1.2 kgm, 7-9 ft.Ibs )

Оригинальная страница руководства