1984-Montero · body and sheet metal a · страница 15 из 71 · Открыть оригинал PDF ↗
ADJUSTMENT
Капот
1. Adjust the longitudinal and lateral positions of the hood
by utilizing the oblong holes in the hinges. (S18597)
2. Adjust the vertical position of the hood by adjusting the
hood bumpers. (S 18597)
Hood Lock and Hood Catch
1. Loosen the hood lock and hood catch stay mounting
screws.
2. Adjust the position of the hood lock and hood catch so
that they are in proper alignment with the hook.
(18W505, 18W567)
NOTE
Apply chassis grease to the sliding part, the rotating part and
the spring of the hood lock.
HOOD HINGE REPLACEMENT
To replace the hood hinges, use a hood hinge kit and follow
these procedures:
1. Remove the hood from the hood hinges.
Caution
Protect the front deck with a rag so that the hood protru-
sions do not damage it.
2. Remove the hood hinges. Use an 8 mm (.32 in.) drill to
break the spot welds which fasten the hinges to the front
deck.
Caution
Be careful not to drill holes in the deck panel.
NOTE
After removing the hinges, make sure that the hinge mount-
ing surfaces on the front deck are flat and level.
23-15
Оригинальная страница руководства
