1984-Montero · body and sheet metal a · страница 51 из 71 · Открыть оригинал PDF ↗
1. Peel the paper off the back of the stripe tape to apply it.
Begin application at the front of the doors and then
proceed to the fender or quarter panel.
Cautions
1. The application should be done in a place with little or
no dust, and at an ambient temperature of 20’ - 40°C
(70” - lOOoF).
2. If the ambient temperature is less than 20°C (70”F),
warm both the tape and the body (application surfaces)
to within 20” - 40°C (70” - lOOoF).
2. Use the spatula to press on the tape, beginning at the
center and moving evenly to both the top and bottom,
in order to remove any trapped air bubbles. (C18156)
Caution
If the spatula is slid to the side there will be slack at the
end of the tape, causing wrinkles, and the tape may deviate
from the correct application position.
3. If the tape is not applied properly it may come off later;
pull the backing paper off straight and slowly. (18C157)
4. If there are any air bubbles in the tape after the applica-
tion is finished, use a sewing needle to make small holes
in the bubbles, and use the corners of the spatula to
press the air out.
Оригинальная страница руководства
