1984 · Рулевое управление — страница 21

Caution · 21

1984-Montero · steering a · страница 21 из 33 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 21
Иллюстрация 2, страница 21

16. Attach the side cover to the cross-shaft and temporarily
tighten the adjusting bolt lock nut.

17. Install the cross-shaft assembly (with the side cover) to
the gear box. (C 13 187)

Caution

1. Do not rotate the side cover during installation.

2. Take care not to damage the cross-shaft oil seal.

Иллюстрация 3, страница 21
Иллюстрация 4, страница 21

18. While turning the adjusting bolt, measure the mainshaft
total starting torque by using the special tool. (Y 1363 1)

Mainshaft total starting torque . . . . . . . . . . . . . . . .
50-90 Ncm (4-8 in.lbs.)

NOTE

Position the mainshaft in the center position during mea-
surement.

19. Tighten the adjusting bolt lock nut to the specified
torque.

Lock nut tightening torque

. . . . . . . . . . . . . . . . . .
30-45 Nm (22-33 ft.lbs.)

Valve Housing and Top Cover

1. Remove the cross-shaft assembly. (Refer to p. 19-I 9.)

2. Remove the valve housing lock nut with the special tool
as illustrated. (13YO33)

3. Remove the valve housing bolts and remove the valve
housing and rack piston while holding the rack piston by
hand to avoid rotation,

Caution

Do not hold housing with rack piston facing downward,
otherwise the rack piston will fall off, scattering the steel
balls.

Иллюстрация 5, страница 21
Иллюстрация 6, страница 21
Оригинальная страница руководства
COMPONENT SERVICE- POWER STEERING GEAR BOX m
100%

Назад
Сверху