1989-Mitsu-Factory Manual · Рулевое управление с усилителем · страница 11 из 40 · Открыть оригинал PDF ↗
NW=!&=,
FLUID LEVEL CHECK
1. Start the engine on a level surface, and turn the steering
wheel several times fully to the right and left while the
engine is idling.
2. Replace the fluid if it has bubbles or has become white.
3. Fill the resetvoir with specified automatic transmission
fluid to the MAX level.
Specified fluid : Automatic transmission fluid DEXRON We
N,SF.JAFb
FLUID REPLACEMENT
Check for contamination in the fluid reservoir. Foamy or
cloudy fluid should be replaced.
I. Remove the reservoir cap.
2. Disconnect the return hose from the reservoir tank and
remove the fluid.
3. Disconnect the high tension cable.
4. Run the engine intermittently several times with the
starting motor, and remove the fluid from the gear box.
5. Attach the return hose and supply the specified fluid.
Specified fluid : Automatic transmission fluid DEXRON tVpe
6. Bleed the system and check the fluid pressure.
N19FUAD
AIR BLEEDING
Check stationary steering effort. If it is different from the
standard value, air in the system is suspected. Bleed the
system.
1. Make certain the reservoir is filled up.
2. Jack up the front wheels.
3. Remove the high tension cable.
4. While turning the steering wheel completely to the right
and to the left, turn the engine over by using the starting
motor. Repeat this several times.
Caution
Do not carry out bleeding with the engine running, high
speed rotation of the oil pump mixes the power
steering fluid with air, making it impossible to through-
ly bleed the system.
Оригинальная страница руководства
