1989-Mitsu-Factory Manual · Рулевое управление с усилителем · страница 21 из 40 · Открыть оригинал PDF ↗
6. APPLICATION OF GREASE TO BUSHINGS
Apply the multipupose grease to the bushings and install
steering column A.
5. INSTALLATION OF BOLT
Assemble steering column A and steering column 6 by
aligning the yellow line on the serrated part of steering
shaft B with the yoke groove in steering shaft A.
4. APPLICATION OF ADHESIVE TO BOLTS
Apply specified adhesive to the nut of steering column B
and tighten the bolt.
Specified adhesive : 3M Adhesive stud locking 4170 or
equivalent
Caution
If there is any adhesive hardened inside the nut, use a
tap to remove it before applying the adhesive.
3. INSTALLATION OF CLEVIS PIN
Insert a new clevis pin until the tip of the pin is flush with
steering column B.
1. INSTALLATION OF BOLT
Align the white line on steering shaft B and the yoke
groove in steering shaft C, and then tighten at the
specified torque.
Оригинальная страница руководства
