1989-Mitsu-Factory Manual · Рулевое управление с усилителем · страница 19 из 40 · Открыть оригинал PDF ↗
(2) Apply the multipurpose grease to the steering shaft C and
D.
Steering shaft D Steering shaft C
1ss734
Caution
After inserting steering shaft D make sure that the tilt of
the yoke of steering shaft D in relation to the yoke of
steering shaft C is within the angle measurement
shown in the illustration.
(3) Assemble the upper and lower boots and the dust cover.
NOTE
Align the arrows on the upper and lower boots to the slits
on the yokes in order to assemble.
31. APPLICATION OF GREASE TO PLATE ASSEMBLYI29. LEVER ASSEMBLY
Siit 138691
When installing the lever assembly and the plate assem-
bly, apply the multipurpose grease to the following
locations:
(1) The surface of the cam part of the lever which contact
steering column B.
(2) The surface of the plate’s clevis pin which contact
steering column B.
(3) The space between the plate’s clevis pin and return
spring.
26. INSTALLATION OF PLATE/25. SPECIAL BOLTS
(1) Apply a coating of the multipurpose grease to the
periphery of the bolt hole at the steering column B and
plate alignment surface.
Оригинальная страница руководства
