Pajero II Workshop Manual 1991 · Кузов · страница 17 из 52 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
WINDSHIELD CLIP STUD REPAIR
If the T-studs are broken, usea drill to make holes in the T-
studs 3 mm (0.12 in:) in diameter, fill the holes with adhesive,
and then use screws to mount the windowmoulding clips
Caution
After installing the clip, apply antirust solvent to the
screwhead to protect them from rust
SERVICE POINTS OF INSTALLATION
8INSTALLATION OF WINDOW SPACER
After cleaning the window spacer adhesion surface of the
windshieldglasswith isopropylalcoholtoremoveall
grease, etc_attach the window spacer as shown in the
figure.
INSTALLATIONOFWINDSHIELDGLASS/6_WIND- SHIELD LOWERMOULDING
(1)When replacing the glass,temporarily set the glass
against the body, and put mating marks on the glass
and body where theymatch,
(2) Install the windshield lower moulding onto the wind-
shield glass
(3) Soaka sponge in the primer, and apply evenly to the
glass and the body in the places shown in the figure
Specified primer: 3M]SuperFastUrethanPrimer
Part No. 8608or equivalent
Caution
The primer strengthens the adhesive strength,
so be sure to apply it evenly around the entire
circumference. Also,a too thick application will
causelowering of the adhesive strength.
2Donot touchthecoated surface.
(4)After applying the primer, let it dry for 3 to 30 minutes
(5) Within 30minutes after applying the primer,fill the
sealantgunwithadhesiveand applytheadhesive
evenly around the entire circumference of the wind-
shield
Specified adhesive: 3MSuper FastUrethanAuto
Glass Sealant Part No: 8609 or
equivalent
NOTE
Cut the nozzle tip of the sealant gun into a V shape to facilitate adhesive application:
PWJe9o86
Оригинальная страница руководства
