Pajero II Workshop Manual 1991 · Кузов · страница 50 из 52 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
CONTROLUNIT
Check for continuity between terminals under the conditions
described below.
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Battery voltage | Terminal |
|---|---|
| When there is | current no |
| When there is | current |
NOTE
0-Oindicates that there is continuity between the terminals
(2)0-Oindicatesthatthereiscontinuitywhenthe (+) is
connected t0 the tester plus terminal, and the (-) is connected
to the testerminus terminal.
(3)Oindicates terminalsto which battery voltage is applied.
SERVICE POINTS OF INSTALLATION
INSTALLATION OF MOTOR ASSEMBLY
When replacing the motor assembly, install by the follow-
ingprocedure.
(1)After installingthefrontguideassembly,setthe
distancebetweenthefrontguideassemblycable
holderandsetplateto 70mm(2.8in:):(Canvas
stopping position)
(2)Set theholeof the intermittentgearso that it is
aligned between the teethof the motor assembly
transmissionand theninstallthemotor
gear,
assembly.
5INSTALLATIONOFREARDRAINHOSE/4FRONT DRAIN HOSE
(1)Tie the rope that was used duringremoval t0 the
endof the drain hose, andwind tape around it sO
that there isno unevenness.
2)Pull the rope to pull the drain hose through:
(3)Pull the drain hose until the protruding length from
the grommet is as shown in the figure_
PWJE9086
Оригинальная страница руководства
