1996 · REAR AXLE [27] · страница 8 из 22 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
(2) Apply gummedcloth tape aroundthe edge of the
bearing case for protection:
(3) As shown in the figure, fix the axle shaft and shave off
with grinder a point of its circumference locally until
the wall thickness on the side of axle shaft of retainer
ring and the side of bearing become approximately
1.0-2.0 mm and 2.0'mm respectively
Caution
Be careful not to damage the bearing case and the
axle shaft:
4) Fix the axle shaft and shave off the remaining 2.0 mm
on the side of the bearing of the retainer.
Caution
Be careful not to damage the bearing case and the
axle shaft;
Cut in witha chisel the place where the retainer ring
has been shaven and remove the retainer.
Caution
Be careful not to damage the axle shaft
AXLE SHAFTSUB ASSEMBLY REMOVAL
(1) Adjust the height of the hanger, and install the plate,
washer, nut in the shown order.
NOTE
If the bar Of the special tool (MB991552) is too short;
install the extension bar (MB991601)
(2) Place the end of the bolt against the centre of the axle
shaft; and then tighten the nut to remove the axle shaft
from the bearing case assembly.
Caution
The hanger and plate should be placed so thatthey
are parallel:
Оригинальная страница руководства
