1996 · REAR AXLE [27] · страница 19 из 22 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

DRIVE PINION PRELOAD ADJUSTMENT

Adjustthedrivepinion turningtorquebyusingthe
following procedure:

Without oil seal

(1) Fit the drive pinion front shim(s) between the drive pinion
spacer and the drive pinion front bearing inner race:

(2) Tighten the companion flange to the specified torque by
using the special tools
NOTE

Do not install the oil seal:

3) Measure the drive pinion turning torque. (without the oil
seal)

Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Bearing division	Bearing lubrication	Rotation torque
New	None (With anti-rust agent)	0.6-0.9 Nm
Newlreusing	Gear oil applied	04-0.5 Nm

(4) If the drive pinion turning torque is not within the range of
the standard value, adjusttheturning torque by replacing
the drive pinion front shim(s) or the drive pinion spacer
NOTE

When selecting the drive pinion front shims, if the number
ofshimsis large,reducethenumber ofshimsto
minimum by selecting the drive pinion spacers.
Also, select the drive pinion spacerfromthe following two
types

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Height of drive pinion spacer mm	Identification colour
52.50	Yellow
52.84	Red

(5) Removethe companion flangeand drive piniononce
again,

With oil seal

1) After setting the drive pinion front bearing inner race, use
the special tool to drive the oil seal into the front lip of the
gear carrier:

(2) Apply a thin coat of clean multi-purpose grease to the
companion flange contact surfaces of the washer andthe
oilseal contactingsurfacebefore installingthedrive
pinion assembly.

Оригинальная страница руководства