1996 · REAR AXLE [27] · страница 18 из 22 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

DRIVE PINION HEIGHT ADJUSTMENT

Adjust the drive pinion height by the following procedures:
Install special tools anddrive pinionfront and rear
bearing inner races to the gear carrier in the sequence
shown in the illustration:

(2) Tighten the nut on the special tool until standard value
of drive pinion turning torque is obtained.

(3) Measure the drive pinion turning torque (without the
oil seal).

Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Bearing division	Bearing lubrication	Rotation torque
New	None (With anti-rust agent)	0.6-0.9 Nm
Newlreusing	Gear oil applied	0.4-0.5 Nm

NOTE

Gradually tighten the nut of the special tool while
checking the drive pinion turning torque

2With small type differentials; one complete rotation
cannot be given to the special tool. Rotate tool
several times within the possible range to run in
the bearing, and then measure the torque:

4) Position the special tool in the side bearing seat of the
gear carrier,then selecta drive pinion rear shim Of &
thickness which corresponds to the gap betweenthe
special tools

NOTE

Thoroughly clean the side bearing seat
When positioning the special tool,be sure that the
cutout sections Of the special tool are in the position
shown in the illustration, and also confirm that the
special tool is in close contact with the side bearing
seat.

When selecting the drive pinion rear shims, keep the
number of shims to a minimum:

5) Fit the selected drive pinion rear shim(s) to the drive
pinion, and press-fit the drive pinion rear bearing inner
race byusingthe special tool.

Оригинальная страница руководства