1996 · REAR AXLE [27] · страница 21 из 22 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SIDE BEARING INNERRACE INSTALLATION

Use the special tool to press-fit the side bearing inner
races into the differential case.

Caution

When only one side bearing inner race is installed; place a
load on the differential case only:

BEARING CAP INSTALLATION

Alignthematingmarksonthegearcarrierandthe
bearing cap, and then tighten the bearing cap.

FINALDRIVE GEAR BACKLASH ADJUSTMENT

Adjust final drive gear backlash as follows:

(1)Using the special tool,temporarily tightenthe side
bearing nut until it is in the state just before preloading
oftheside bearing:

(2) Measure the final drive gear backlash.
Standard value: 0.13-0.18 mm

NOTE

Measure at four points or more on the circumference
of the drive gear.

(3) Use the special tool (MB991367andMB991385) to
adjust the backlash to the standard value by moving
the side bearing nut as shown_

NOTE

First turn the side bearing nut for loosening; and then
turn the side bearing nut for tightening bythesame
amount

Оригинальная страница руководства