MANUALS · SUPPLEMENTAL RESTRANT SYSTEM (SRS) [52B] · страница 16 из 48 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

From previous page

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Code No. 42 IG1 (B) power circuit system	Probable cause
(Comment] This diagnosis code is output if the voltage between the IG, (B} terminal and the is lower than the specified value for continuous period of 5 seconds earth more. However; if the vehicle condition returns to normal for a continuous period of 5 diagnosis code No. and the SRS t 0.2 seconds will be automatically erased_ warning lamp will switch off.	Malfunction of harnesses or connectors

Turn the ignitionkeyto theLOCK" position, disconnect
the negative battery cable and tape the terminal.

Caution

Wait at least 60 seconds after disconnecting the bat-
tery cable before doing any further work (Refer to
P 52B-4)

2Remove the floor console assembly: (Refer to GROUP
52AFloor Console.)

3Place a flat-tipped (~) screwdriver against the lock spring
(metal portion) of the SDU connector lock lever; and push
the spring horizontally toward the inside of the unit
Caution

Do not use excessive force to raise the lock lever
(green).

Do not insert the screwdriver into the gap between
the lock lever (green) and the Iock spring (metal
portion).

Disconnect the red14-pin connector from the SDU.

ADDED

PWJE9086 -E

Оригинальная страница руководства