MANUALS · SUPPLEMENTAL RESTRANT SYSTEM (SRS) [52B] · страница 46 из 48 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Disconnect the negative (~) and positive (+) battery cables
from the battery terminals, and then remove the battery
from the vehicle

Caution

Wait at least 60 seconds after disconnecting the bat-
tery cables before doing any further work: (Refer to
P52B-4.)

(2)Remove the airbagmodule from the vehicle_(Refer to
P.52B-38.)

Caution

The air bag module should be stored on a flat surface
and placed sothat the pad cover face up. Donot
place anything on top of it.

(3)Connect twowires, eachsix meters long ormoreto
the two leads of SRS AIR BAG ADAPTER HARNESS B,
and cover the connections with insulation tapeThe other
ends of the two wires should be connected to each other
(short-circuited), to prevent sudden unexpected deploy-
ment of the air bag:

(4}Install nuts that are no longer needed to the four bolts
on the rear side of the airbagmodule, and tie on some
thick wire to secure to the wheel:

(5)Take the SRS airbagadaptor harness B that is connected
to the wires, pass it beneath the old tyre that is attached
to the wheel, and connect it to the airbagmodule

(6)Insert the airbagmodule into the wheel on which the
old tyre has been installed, and secure it with the wires
that are tied to the bolts, with the air bag facing upward.
Caution

Leave some space below the wheel for the adaptor
harness. If there is no space, the reaction when the
air bag deploys could damage the adaptor harness:

Оригинальная страница руководства