MANUALS · SUPPLEMENTAL RESTRANT SYSTEM (SRS) [52B] · страница 36 из 48 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

DISCONNECTIONOFTHESDUANDEACHHAR-
NESS CONNECTOR

(1)Place a flat-tipped (~) screwdriver against the lock spring
(metal portion) of the SDU connector lock lever; and push
the spring horizontally toward the inside of the unit_

Caution

Do not use excessive force to raise the lock lever
(green)

2Do not insert the screwdriver into the gap between
the lock lever (green) and the lock spring (metal
portion )

(2)While pushing the locks of each connector downwards,
remove each connector from the SDU.

Caution

Becausedouble lock mechanism is employed for
the SDU connectors, be careful not to exert undue
force to remove the connectors, as this will damage
them:

Проверка

ES2BHOZAA

Check the SDU case and brackets for dents, cracks or
deformities,

Check connectors and lock lever for damage, and terminals
for deformities_

Caution

If a dent, cracks, deformation or rust discovered, re-
place the SDUwithnew one:

NOTE

For checking of the SDU other than described above,
referto the section concerning troubleshooting: (Refer
to P.52B-7.)

Оригинальная страница руководства