MANUALS · HEATER, AIR CONDITIONER AND VENTILATION [55] · страница 28 из 118 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

REMOVAL AND INSTALLATION

Pre-removal and Post-installation
Operation
Removal and Installation of the Rear
Seat

(Refer to GROUP 52Seat)
<Except for Long Body Wagon>

Removal steps

Cover

Air guide

3. Linkage mounting screw

Rear air mix damper motor assembly
<Vehicles with dual AC >
Control switch assembly

<Vehicles with dual AC >
Resistor

Проверка

ESsREBA

REAR AIR MIX DAMPER MOTOR ASSEMBLY CHECK

(1) Checkthat the temperature adjustment selector is nor-
mal. (Refer to P.55-15.)

(2) After the engine has warmed up, check that the link of
the damper motor is at position A when the temperature
adjustmentselector isat theMAXCOOL position,and
that it is at position B when the temperature adjustment
selector is at the MAXHOT position.

CONTROL SWITCH CHECK

Operate theswitchandusecircuit testerto checkthe
continuity between the terminals in both theandB posi-
tions

RESISTOR CHECK

Usecircuit tester to measure the resistance between the
terminals shown below. Check that the values measured are
within the standard values_

Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Measurement terminal	Standard value Q
Between terminals	4.3 + 7%
Between terminals	1.2 + 7%

Mitsubishi Motors CorporationFeb. 1991

Оригинальная страница руководства