MANUALS · HEATER, AIR CONDITIONER AND VENTILATION [55] · страница 118 из 118 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
9
INSTAELATION OF FRONT HOUSING
(1) Apply the specified compressor oil on the shaft:
Specified compressor oil:
<Vehicles using R-12 refrigerant >
DENSO OIL 6
Vehicles using R-134a refrigerant >
ND-OIL 8
(2) Install the front housing. taking care not to damage the
lip part of the shaft seal:
(3) Mount the bolt onthe shaft, and thenmeasure the
shaft starting torque.
Standard value:5.0 Nm (0.5 kgm, 3.6 ft.Ibs )
orless
(4) Remove the bolt from the shaft:
INSTALLATION OF CLUTCH COIL
The clutch coil must be aligned with the pin in the com-
pression housing:
ADJUSTMENT OF CLUTCH CLEARANCE
(1) Connect the magnetic clutch to the battery_
The clutch hub will be attracted to and fit closely to
the rotor,
(3)Useshim(s) to adjust so that the amount of move
ment of the clutch hub is as described below
Standard value:0.35-0.65 mm
(0.0138-0.0256 in.)
Оригинальная страница руководства
